Port Jervis electricians for river-town houses and flood repair
Port Jervis sits where the Neversink meets the Delaware, and the river has come into town more than once. Flood repair, raised panels and generator hookups are a big part of the work here. A person answers our line at any hour.
- Flood and storm repair
- Generators and backup
- Calls answered 24/7
- Flood-damaged panels and circuits
- Panels raised above flood lines
- Generator hookups
We do electrical work in Port Jervis from our Warwick head office: flood-damaged panels and basement circuits, raising service equipment above flood lines, generator hookups and standby units, and repairs in older city homes. Port Jervis is on Orange and Rockland, inspections go through approved agencies, and calls to (929) 755-0293 are answered 24/7.
Rather ask a person?(929) 755-0293A river town with a flood history
The Delaware River flooded Port Jervis three times in less than two years, in September 2004, April 2005 and June 2006. On June 28, 2006, the river at Port Jervis crested at 21.47 feet, the highest since the flood of August 1955, and backwater from the Delaware pushes into the Neversink near its mouth. In winter, ice jams at the bend above the confluence can flood the west end of town.
That history is in the basements. Older houses near the river often have the panel, the meter and the laundry circuits low on a basement wall, exactly where water reaches first. After a flood, nothing should be switched back on until wet devices and panels are checked, and when equipment is replaced it is worth raising it above the high-water mark. Since December 31, 2025, permitted work follows the 2023 NEC.
The Port Jervis jobs we see most
Storm & Flood Electrical Repair
Flood-damaged panels, outlets and basement circuits checked and replaced before the power goes back on.
DetailsElectrical Panel Replacement
Panels replaced and raised above the high-water mark in river-side basements.
DetailsSump Pump Wiring & Backup
Sump pumps on dedicated circuits, with battery backup for the outages that come with high water.
DetailsTransfer Switch & Interlock
Inlet boxes and interlock kits so a portable generator can carry essential circuits.
DetailsElectrical Safety Inspection
Inspections after a flood, a purchase or an insurance request on older homes.
DetailsWhole-House Surge Protection
Surge protection at the panel for houses on lines that see storm outages and restarts.
DetailsPermits and inspection in Port Jervis
Permits come from the City of Port Jervis, or the Town of Deerpark for addresses outside the city, and electrical work is inspected by an independent agency the municipality approves; Deerpark publishes its own list of approved electrical inspectors. Flood repairs that replace a panel or service need the permit and inspection before the utility will restore power to the equipment.
Covered from the Warwick head office
Port Jervis calls run from our head office at 27 W Lake Rd in Warwick. Call (929) 755-0293 at any hour; after high water we ask where the water reached first, then tell you what is safe and when a crew can get to the house.
Port Jervis and nearby places we cover
- City of Port Jervis
- Sparrow Bush
- Deerpark
- Huguenot
- Greenville
- Mount Hope
Anywhere else around Port Jervis on the New York side, call with the address and we will confirm.
Port Jervis questions
Not until the wet panel and circuits are checked. Water can leave parts energized or corroded, so we test before anything is switched back on.
If it took water, raising it above the high-water mark when it is replaced is usually the right move, along with the meter where the utility allows.
Replacing a panel or service does, and the inspection has to pass before the utility restores power to the new equipment.
Yes, through an inlet and interlock or transfer switch, with the pump on its own circuit so it is easy to keep running.